首页 >> 资讯动态 >>产品资讯 >> 机房精密空调如何维护保养
详细内容

机房精密空调如何维护保养

对于机房精密设备而言,保持稳定的温湿度环境有助于设备的稳定运行。因此,安装机房精密空调是十分有必要的。但需要注意的是,精密空调同样属于精密设备,需要定期维护保养,让精密空调系统保持良好的运行工况,以期延长设备使用寿命,降低设备故障率,避免因空调系统故障而带来机房内其他设备的损失。

那么,机房精密空调应如何维护保养呢?

For precision equipment in the machine room, maintaining a stable temperature and humidity environment is conducive to the stable operation of the equipment. Therefore, it is very necessary to install the machine room precision air conditioning. However, it should be noted that precision air conditioning is also precision equipment, which needs regular maintenance to keep the precision air conditioning system in good operating conditions, so as to extend the service life of the equipment, reduce the failure rate of the equipment, and avoid the loss of other equipment in the machine room caused by the failure of the air conditioning system.

Then, how should the machine room precision air conditioning maintenance?


  1. 机房精密空调水冷型冷凝器的保养

    Maintenance of water cooled condenser for precision air conditioner in machine room

    (1)适时排除冷凝器中混入的不凝性气体和润滑油。

      (1) Timely eliminate non-condensable gas and lubricating oil mixed in the condenser.

    (2)根据精密空调冷却水系统的运行情况,定期清洗冷却塔接水盘和管道系统中设置的除污器、水过滤器。

      (2) According to the operation of the cooling water system of the precision air conditioner, clean the water collector and water filter installed in the water tray of the cooling tower and the pipeline system regularly.

    (3)注意精密空调冷却水水质的检测,发现水质恶化,要将系统中使用的冷却水部分或全部置换。

      (3) Strengthen the detection of the water quality of the cooling water of the precision air conditioner, find that the water quality is deteriorating, and replace part or all of the cooling water used in the system.

    (4)注意精密空调冷凝器传热管的结垢情况,如果结垢严重,应及时除垢。为延缓结垢速度,可在冷却水中加入适量阻垢剂。也可以采用经水处理的冷却水(净化水、蒸馏水)。 

      (4) Pay attention to the scaling of the heat pipe of the condenser of the precision air conditioner. If scaling is serious, remove scaling in time. In order to slow down scaling, appropriate amount of scale inhibitor can be added to the cooling water. Water treated cooling water can also be used.


  2. 机房精密空调风冷型冷凝器的保养

    对于精密空调风冷式冷凝器的正常保养主要是根据传热翅片上积灰情况,定期进行吹除或清洗,以保持传热面的清洁。

    For the normal maintenance of the air cooled condenser of precision air conditioning, it is mainly based on the ash accumulation on the heat transfer fins, regularly blowing away or cleaning, so as to keep the heat transfer surface clean.


  3. 机房精密空调蒸发器的保养

    Maintenance of precision air-cooled condenser in machine room

    (1)为确保导热效果,应定期清除蒸发器传热翘片上的积灰,可采用压缩空气吹除或冲洗方式。

      (1) In order to ensure the heat conduction effect, the ash accumulated on the heat transfer warped plate of evaporator should be removed periodically. Compressed air can be used to blow away or flush.

    (2)冷库用蒸发器,应视霜层的厚度及时对排管除霜。

      (2) The evaporator for cold storage should defrost the discharge pipe in time according to the thickness of frost layer.


  4. 机房精密空调其它部件的保养

    Maintenance of other parts of precision air conditioner in machine room

    (1)干燥过滤器:要随时注意液流指示器对制冷剂含水量的指示,当它的指示片为淡红色时,干澡过滤器中的干燥剂失效,应立即更换干燥剂。

      (1) Drying filter: pay attention to liquid flow indicator's indication of refrigerant water content at any time. When its indicator piece is pink, the desiccant in the dry bath filter fails, and the desiccant should be replaced immediately.

    (2)中间冷却器、气液分离器:定期对浮球阀进行检查以及在机组大修时进行吹除和承压试验,分离器中有加热装置时还应定检查加热装置。

      (2) Intercooler and gas-liquid separator: check the ball float valve regularly and carry out blow off and pressure test during the overhaul of the unit. Check the heating device when there is a heating device in the separator.


  5. 唐山机房精密空调销售安装和维修保养

    Tangshan machine room precision air conditioning sales installation and maintenance

    唐山昱信环保设备有限公司专业进行海信等品牌机房精密空调系统的设计、销售、安装和售后维护保养,由专业的设计师根据机房热负载情况、设备布局等进行设备选型、风道优化,并有专业安装团队严格按照安装规范进行安装作业。并提供完善的售后维保服务,欢迎唐山市及唐山周边区域客户联系。

    Tangshan yu environmental protection equipment co., LTD is specialized in the letter to hisense brands such as computer room precision air conditioning system design, sales, installation and after-sale maintenance, by professional designers according to engine thermal load conditions, equipment layout, equipment selection, the optimization of air duct, and has a professional installation team in strict accordance with the specifications for installation. And to provide perfect after-sales maintenance services, tangshan and tangshan area customers are welcome to contact.

技术支持: 天啦噜网络科技 | 管理登录